Mercury Slip Ring - Mercotac Model 430

Model 430
Four Conductors,
2@4amps, 2@30amps

 


Disconnects included
(4 sm., 4 lg.)
Boot kit available
Available with stainless steel ball bearings (430-SS)
Model No. Terminals Voltage
AC/DC
Amp
Rating
@240VAC
Max.
Freq.
MHz
Contact
Resistance
Max.
RPM
Temp
Max. F (C) /
 Min. F (C)
Rotation
Torque (gm-cm)
Circuit
Separation
104E
430 4 0-250 2@4/2@30 100

<1m

1200 140 (60) /-20(-29) 400

>25M

430-SS 4 0-250 2@4/2@30 100

<1m

1200 140 (60) /-20(-29) 400

>25M

"SS" designator indicates stainless steel ball bearing (recommended for wet or corrosive environments)

430 Accessories

50431
Plug Assembly 12 in. wires
14 AWG & 18 AWG
Suitable for up to 20 Amps
50431
Plug Assembly 12 in. wires
14 AWG & 18 AWG
Suitable for up to 20 Amps
1052 50430
Plug Kit - No wires, terminals for wire gauges
20 - 16 AWG & 16 - 14 AWG
Suitable for up to 20 Amps
Also order 5030-T
57430
Boot Kit for dust or splash protection
IP51
55251
Terminal 16 - 14 AWG
(qty. 2 included)
5030-T
Plug Terminal Crimping Tool
For Use With 50430 Kit
55250
16 - 14 AWG (qty. 2 included)
55110
22 - 18 AWG (qty. 4 included)
Terminals for other wire gauges available.
(22-18 AWG and 12-10 AWG)
430 Standard Wire Connections

430 Wire Connections With Optional Boot
  430 Suggested Mounting Methods
Model 430 is typically mounted by either the black body or the white plastic 1037 bushing on either end using a set screw.  When mounting horizontally, mount the Mercotac so the body of the connector rotates.

Typical Body Mount Hole Dimensions

MODEL HOLE DIAMETER () * DEPTH
430 et al 1.248"    (31.70) .80"    (20)

Typical Bushing Mount Hole Dimensions

430 et al .625"    (15.88) .40"    (10)
With Plug Connector .625"    (15.88) 1.40"   (36)
*Inch  (mm) Tolerance   +.001" (+.025)
    -.000" (-.000)











Installation Notes:
  • the up arrow should not point below horizontal
  • do not solder to or bend connector tabs
  • avoid lateral forces and mechanical loads (overly stiff or tight wires)
  • do not rigid mount both ends of connector
  • limit mounting eccentricity (runout / wobble) to .005" (.13mm)
  • provide overload protection within the circuit
  • avoid vibration and bumping motions

Back Top Top