Low Cost Slip Ring - Mercotac Model 205

Model 205
Two Conductors,
4 Amps


High-speed model available (205-H)
Low-torque/low-temp. models available (205-L)
Available with stainless steel ball bearings (205-SS)
Model No. Terminals Voltage
AC/DC
Amp
Rating
@240VAC
Max.
Freq.
MHz
Contact
Resistance
Max.
RPM
Temp
Max. F (C) /
 Min. F (C)
Rotation
Torque (gm-cm)
Circuit
Separation
104D
205 2 0-250 4 200 104C

<1m

2000 140 (60) /45(7) 75

>25M

205-SS 2 0-250 4 200

<1m

2000 140 (60) /45(7) 75

>25M

205-L 2 0-250 4 200

<1m

1200 140 (60) /-20(-29) 20

>25M

205-LS 2 1048 0-250 4 200

<1m

1200 140 (60) /-20(-29) 75

>25M

205-H 2 0-250 4 200

<1m

3600 140 (60) /45(7) 35

>25M

205-HS 2 0-250 4 200

<1m

3600 140 (60) /45(7) 35

>25M

"SS" designator indicates stainless steel ball bearing (recommended for wet or corrosive environments)
"L" designator indicates low torque / low temp.
"LS" designator indicates low temp. & stainless steel ball bearing
"H" designator indicates high RPM
"HS" designator indicates high RPM & stainless steel ball bearing

205 Accessories
592
two contact receptacle 
w/ 6" wires
(18 AWG)
591
two contact receptacle
w/ one 6" wire
(18 AWG)
594
two contact receptacle 
w/ two solder holes
for 18 AWG wires
595
two contact cap
w/ two solder lugs
 

Receptacle used for mounting to rotating device.
Accessories are required for wire connections.  Order Separately.

205 Connections

1062
205 Suggested Mounting Methods
Model 205 is typically mounted by the knurled metal receptacle, which is press-fit into the rotating member of the machine.  When mounting horizontally, mount the Mercotac so the body of the connector rotates.

Receptacle Mount Hole Dimensions

MODEL HOLE DIAMETER () * DEPTH
591, 592, 594 .283"    (7.19) .35"    (8.89)
*Inch  (mm) Tolerance   +.001" (+.025)
    -.000" (-.000)

B5C










Installation Notes:
  • the up arrow should not point below horizontal
  • do not solder to or bend connector tabs
  • avoid lateral forces and mechanical loads (overly stiff or tight wires)
  • do not rigid mount both ends of connector
  • limit mounting eccentricity (runout / wobble) to .005" (.13mm)
  • provide overload protection within the circuit
  • avoid vibration and bumping motions

Back Top Top