Brush Slip Ring Replacement - Mercotac Model 435

Model 435
Four Conductors,
4@30amps


Disconnects included 
(8 lg.) 
Boot kit available 
Available with stainless steel ball bearings (435-SS) 
Model No. Terminals Voltage
AC/DC
Amp
Rating
@500VAC
Max.
Freq.
MHz
Contact
Resistance
Max.
RPM
Temp
Max. F (C) /
 Min. F (C)
Rotation
Torque (gm-cm)
Circuit
Separation
435 4 0-500 30 100

<1m

300 140 (60) /-20(-29) 850

>50M

435-SS 4 0-500 30 100

<1m

300 140 (60) /-20(-29) 850

>50M

"SS" designator indicates stainless steel ball bearing (recommended for wet or corrosive environments)

435 Accessories
55250
16 - 14 AWG (qty. 4 included)
55251
Terminal 16 - 14 AWG
(qty. 4 included)
57435
Boot Kit for dust or splash protection
IP51
1064 Terminals for other wire gauges available.
(22-18 AWG and 12-10 AWG)
435 Standard Wire Connections

435 Wire Connections With Optional Boot Kit
435 Suggested Mounting Methods
Model 435 is typically mounted by either the black body or the white plastic bushing on either end using a set screw.  When mounting horizontally, mount the Mercotac so the body of the connector rotates.
18A8

Typical Body Mount Hole Dimensions

MODEL HOLE DIAMETER () * DEPTH
435 et al 1.772"    (45.00) .80"    (20)

Typical Bushing Mount Hole Dimensions

435 et al 1.250"    (31.75) .80"    (20)
*Inch  (mm) Tolerance   +.001" (+.025)
    -.000" (-.000)











Installation Notes:
  • the up arrow should not point below horizontal
  • do not solder to or bend connector tabs
  • avoid lateral forces and mechanical loads (overly stiff or tight wires)
  • do not rigid mount both ends of connector
  • limit mounting eccentricity (runout / wobble) to .005" (.13mm)
  • provide overload protection within the circuit
  • avoid vibration and bumping motions

Back Top Top