Replace Sliprings with Mercotac Electrical Sliprings - Model 830

Model 830
Eight Conductors,
2@4amps, 6@30amps

Disconnects included
(4 sm., 12 lg.)
Boot kit available
Available with stainless steel ball bearings (830-SS) 


Model No. Terminals Voltage
AC/DC
Amp
Rating
@240VAC
Max.
Freq.
MHz
Contact
Resistance
Max.
RPM
Temp
Max. F (C) /
 Min. F (C)
Rotation
Torque (gm-cm)
Circuit
Separation
830 8 0-250 2@4/6@30 100 1036

<1m

200 140 (60) /-20(-29) 1000

>25M

830-SS 8 0-250 2@4/6@30 100

<1m

200 140 (60) /-20(-29) 1000

>25M

"SS" designator indicates stainless steel ball bearing (recommended for wet or corrosive environments)

830 Accessories
2627
55110
22 - 18 AWG (qty. 4 included)
55253
Shrink Tube (qty. 6 included)
55252
Terminal 16 - 14 AWG 
(qty. 6 included)
55251
Terminal 16 - 14 AWG
(qty. 6 included)
57830
Boot Kit for dust or splash protection
IP51

Terminals for other wire gauges available.
(22-18 AWG and 12-10 AWG)

830 Standard Wire Connections

830 Wire Connections With Optional Boot Kit
830 Suggested Mounting Methods
Model 830 is typically mounted by either the black body or the white plastic bushing on either end using a set screw.  When mounting horizontally, mount the Mercotac so the body of the connector rotates.

Typical Body Mount Hole Dimensions

MODEL HOLE DIAMETER () * DEPTH
830 et al 1.772"    (45.00) .80"    (20)
Typical Bushing Mount Hole Dimensions
830 et al 1.125"    (28.58) .40"    (10)
*Inch  (mm) Tolerance   +.001" (+.025)
    -.000" (-.000)












Installation Notes:
  • the up arrow should not point below horizontal
  • do not solder to or bend connector tabs
  • avoid lateral forces and mechanical loads (overly stiff or tight wires)
  • do not rigid mount both ends of connector 7A5
  • limit mounting eccentricity (runout / wobble) to .005" (.13mm)
  • provide overload protection within the circuit
  • avoid vibration and bumping motions

Back Top Top